-
- About 30 minutes
hello kitty charm bracelet
Make a fun charm bracelet using themed charms and crystal bicone beads!
| Step 1 |
Make bead drop charms from crystal bicone beads to hang between your charms. Slide a bead onto an eye pin from your earring kit. Bend the wire of the eye pin in a 90° angle just above the bead. Grasp the eye pin wire, about 3/8"-½" [0.3 cm-1.3 cm] from the bend, between the jaws of your round nose pliers. Rotate the pliers toward you, keeping a firm grip on the wire, until a small loop is formed. Trim excess wire. Set aside. |
| Step 2 |
Layout your charm bracelet and plan where you want your themed charms and your bicone drops. |
| Step 3 |
Add charms! Remove the jump rings from the charms and use new jump rings from your earring kit to attach to your bracelet. To open and close a jump ring, simply grasp the jump ring on both sides with chain nose pliers and twist the ring open, from side-to-side. Never pull the jump ring which can cause distortion. |
-
809188158You’ll Need: 1Item # 10698084Promotions
$11.99- Color: Gold
- Color: Gold
- Color: Gold
-
-
809188134You’ll Need: 1Item # 10686722Promotions
$11.99- Color: Crystal
- Size: 6 mm
- Color: Crystal
- Size: 6 mm
- Color: Crystal
- Size: 6 mm
-
809188134You’ll Need: 1Item # 10686740Promotions
$11.99- Color: Light Rose AB
- Size: 6 mm
- Color: Light Rose AB
- Size: 6 mm
- Color: Light Rose AB
- Size: 6 mm
Products
Products
| Step 1 |
Make bead drop charms from crystal bicone beads to hang between your charms. Slide a bead onto an eye pin from your earring kit. Bend the wire of the eye pin in a 90° angle just above the bead. Grasp the eye pin wire, about 3/8"-½" [0.3 cm-1.3 cm] from the bend, between the jaws of your round nose pliers. Rotate the pliers toward you, keeping a firm grip on the wire, until a small loop is formed. Trim excess wire. Set aside. |
| Step 2 |
Layout your charm bracelet and plan where you want your themed charms and your bicone drops. |
| Step 3 |
Add charms! Remove the jump rings from the charms and use new jump rings from your earring kit to attach to your bracelet. To open and close a jump ring, simply grasp the jump ring on both sides with chain nose pliers and twist the ring open, from side-to-side. Never pull the jump ring which can cause distortion. |